Post by tgabreu on Aug 18, 2013 6:09:28 GMT -6
I was going through some older pictures this week, and came across these. It's a 3/8 scale clay model of a 50th Anniversary Corvette proposal. GM nixed the idea, but my boss and another company bought the rights to the design and produced some 1/1 conversions.
My boss did the clay work, a co-worker made a lot of the trim parts from aluminum. I made some of the trim parts, and did the paint. I also made the table, which has properly graduated 3/8 scale styling rails, as well as the uprights and bridge (not shown).
Tom
My boss did the clay work, a co-worker made a lot of the trim parts from aluminum. I made some of the trim parts, and did the paint. I also made the table, which has properly graduated 3/8 scale styling rails, as well as the uprights and bridge (not shown).
Tom